Two Ways to Make SanDisk USB Flash Drive Bootable

Two Ways to Make SanDisk USB Flash Drive Bootable

Geeks - Creating a bootable USB flash drive can be useful in a variety of situations, such as installing an operating system on a new computer or recovering a damaged system. If you have a SanDisk USB flash drive, you can make it bootable in two main ways: using a bootable USB creation tool or using the command prompt.

Method 1: Using a Bootable USB Creation Tool

One of the easiest ways to make a SanDisk USB flash drive bootable is by using a bootable USB creation tool, such as Rufus or UNetbootin. These tools allow you to create a bootable USB from an ISO file, which is a complete image of an operating system or other bootable software.

To use a bootable USB creation tool:

Download and install the bootable USB creation tool on your computer.

Connect your SanDisk USB flash drive to your computer.

Launch the bootable USB creation tool and select the ISO file you want to use to create the bootable USB.

Select the SanDisk USB flash drive as the target device.

Follow the instructions provided by the tool to create the bootable USB. This process may take a few minutes to complete.

Method 2: Using the Command Prompt

If you prefer a more manual approach, you can also use the command prompt to make your SanDisk USB flash drive bootable. This method requires you to have access to the command prompt and to have an ISO file of the operating system or other bootable software you want to install on the USB flash drive.

To use the command prompt to create a bootable USB:

Connect your SanDisk USB flash drive to your computer.

Open the command prompt and type the following command to determine the drive letter assigned to your USB flash drive:

Copy code

diskpart

list disk

Type the following command to select the USB flash drive, replacing X with the drive letter of your USB flash drive:

Copy code

select disk X

Type the following command to clean the USB flash drive and prepare it for the bootable software:

Copy code

clean

Type the following command to create a primary partition on the USB flash drive:

Copy code

create partition primary

Type the following command to select the partition and assign it a drive letter:

Copy code

select partition 1

assign letter=X

Type the following command to format the USB flash drive with the NTFS file system:

Copy code

format fs=ntfs quick

Type the following command to set the USB flash drive as active, which is necessary for it to be bootable:

Copy code

active

Type the following command to exit the diskpart utility:

Copy code

exit

Type the following command to copy the contents of the ISO file to the USB flash drive, replacing X with the drive letter of your USB flash drive and path_to_ISO_file with the location of the

·